Baby Lock Model BLCS Bedienerhandbuch PDF herunterladen (Seite 36)

1. Open the front cover and raise the presser foot.

2. At the threading port, cut the chain looper thread. (fig.A)

Remove thread from under the presser foot and the upper

thread guides. Replace cone of thread with specialty thread.

3. Place the machine in "locked" position to thread the chain

looper.

4. Thread specialty thread into the upper thread guides, leav-

ing an 18 inch (40cm) tail above the threading port. (fig.C)

5. Cut a 24 inch (55cm) strand of serger thread and fold in half

to form a thread cradle. Insert the loose ends of the thread

cradle into the port about 1 inch (2.5cm).

6. Holding the cradle loop with left hand, depress the threading

lever with your right hand (fig.D) until the thread ends come

out the looper eye. Open side door of machine to make sure

thread is in eye of chain looper.

7. Insert the specialty thread tail into the cradle loop (fig.E),

pull the serger thread ends until the specialty thread comes

through the looper eye (fig.F). Discard or set aside the

thread cradle.

8. Cut chain looper thread 4inches (10cm) and place in tray

Close side door of machine. (fig.G)

Thread Cradle for Looper

E F G

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 42 43 44

Keine Kommentare

Baby Lock Model BLCS Bedienerhandbuch Seite 36